Optional) Configuring A Stack Id For The S3700; Optional) Configuring A Stack Priority For A Device - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Device Management
By default, the stacking function is enabled.
----End

3.5.4 (Optional) Configuring a Stack ID for the S3700

Context
Stack IDs can be configured before or after the stack system is created. By default, stack IDs of
member switches in a stack are all 0s. If stack IDs are not configured for member switches before
the stack system is created, the stack system assigns stack IDs to member switches after being
created. After the stack system is created successfully, all the configuration of the stack system
can be performed on the master switch only.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
stack slot slot-id renumber new-slot-id
A stack ID is configured for a device.
By default, the stack ID of a device is 0.
----End

3.5.5 (Optional) Configuring a Stack Priority for a Device

Context
The stack priority of a device can be configured before or after the stack system is created. If
the stack system is created, you can configure stack priorities on the master switch only; if the
stack system is not created, you can configure a stack priority on each device.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
Issue 01 (2011-07-15)
NOTE
If you run the undo stack enable command to disable the stacking function on the S3700, the configuration
takes effect only after the S3700 is restarted. If you run the stack enable command to enable the stacking
function on the S3700, the configuration takes effect only after the S3700 is restarted.
NOTE
After the stack ID is configured, the configuration takes effect only after the device is restarted. The stack
slot-id command is valid only on the device where the stacking function is enabled.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Stacking
35