NEC Univerge sv8500 Manual page 2748

8. Distributed Communication Server (DCS)
8.1 General
8.1.1 Outerview
This section covers how to install and maintain the Distributed Communication Server (DCS), an optional remote
server system. The figure below shows the outer view of the DCS.
8.1.2 Related Reference Manuals
This manual does not cover the information related to the Telephony Server. If you need such information,
please refer to the following manuals, too:
MANUAL
UNIVERGE SV8500
Installation Manual
UNIVERGE SV8500
Operations and Maintenance
Manual
UNIVERGE SV8500
Circuit Card Description
Table 2-1 Related Reference Manuals
This manual covers the following procedures, required for:
• the installation of the Telephony Server and other necessary equipment.
• the initial power-on and start-up of installed Telephony Server.
• confirmation of the system's normal operations (post-installation test).
This manual explains how to operate and maintain the installed system. The contents in-
clude:
• The way to detect/diagnose a fault.
• Measure(s) to be taken in case of fault encountering.
• The outline of maintenance commands and their parameters.
• Other operating procedures of the Telephony Server and its routine maintenance, etc.
This manual describes the functional outline, mounting location, lamp indications and
switch setting, etc. of the circuit cards used in the Telephony Server.
VOL.3-261
CHAPTER 2 TERMINAL-RELATED DEVICES
CONTENTS