NEC Univerge sv8500 Manual page 2373

Item
QoS
(2) Front panel
Part
PWR lamp
ALM lamp
ONLINE lamp
LOAD lamp
USB connector
PC CARD slot
SYSTEM
switch
LINK
Ether1
connector
100M
Ether2 LINK
connectorNote
100M
3
If you want to operate an SR-MGC(S) with off-line mode, turn it on with the SYSTEM switch 1 set to on.
Note 1:
IEEE802.1p (ToS field is supported, Diffserv)
Condition
ON (green) CPU is powered on.
OFF CPU is powered off.
ON (red) MJ alarm
Flash (red) MN alarm
OFF Normal operation
ON (green) SP runs and operates properly.
Slow flash
TP runs; SP is not.
(green)
Rapid flash
TP runs; a program is not installed.
(green)
Flash* Cannot be activated because of bad li-
(green) cense.
OFF The system does not run.
ON (red) Accessing to a CF card.
OFF No access to a CF card.
- Not used.
- For inserting a CF card.
ON Off-line
1
OFF Normal
2 - Not used.
3 - Not used.
4 - Not used.
ON (green) Connection is established.
Flash
Accessing.
(green)
OFF Connection is not established.
ON (green) 100Mbps
OFF 10Mbps
-
Not used.
-
VOL.2-2120
Specification
Description
modeNote1Note2
SR-MGC(S)
Remarks
*Flash pattern:
flashes twice; off
two sec
Basic setting
RJ-45 for Ethernet
connection of 10/
100M