NEC Univerge sv8500 Manual page 3080

4.4.4 Simple Test Mode
Simple Test Mode parameter has the following additional parameters: Test Call On, Call Test Address, Key Test
(Random), Key Test (Seq.), Voice Loopback and Speaker Test.
4.4.4.1 Test Call On
On the Test Call On parameters, perform the telephone call test.
The Call Test Address parameter must be assigned before starting the test. Refer to 4.4.4.2 Call Test Ad-
Note:
dress.
STEP 1: Select "4. Simple Test Mode" by pressing "4" key on the Maintenance Settings Menu.
"6. Auto Config" is not supported by DtermIP (SIP) with Firmware Version 4.1.x.x.
Note:
STEP 2: Select "1. Test Call On" by pressing "1" key on the Simple Test Mode Menu.
STEP 3: The telephone call test is started. The display changes as follows:
Maintenance Settings Menu
41.Download Menu
2.Hard Reset
3.Factory Value
4.Simple Test Mode
5.Config Password Mode
6.Auto Config
Up Down
Simple Test Mode Menu
441.Test Call On
2.Call Test Address
3.Key Test(Random)
4.Key Test(Seq.)
5.Voice Loopback
6.Speaker Test
Up
Down
VOL.3-593
CHAPTER 4 CONFIGURATION SETUP
Exit
Exit