NEC Univerge sv8500 Manual page 2447

Execute the following to change settings on the SR S side:
STEP 1: Use telnet to log on to the SR S (in Windows 2000, use Start
Command Prompt). Telnet is accessible from any PC connected to a network..
telnet 172.16.253.1
Login screen will be displayed; enter the following:
login: SV7000
password:
[SV7000@SRMGC_SP~]$
STEP 2: Enter data setting commands.
[SV7000@SRMGC_SP~]$ sudo
SP_CONFIG
password:
Specify the IP Address. The following is an example of assigned values.
A list of pre–registered values will be displayed.
SR-MGC(SP) config script
(Current Data List)
SR-MGC(SP) IP address [172.16.253.1]
SR-MGC(SP) Netmask [255.255.255.0]
SR-MGC(SP) default gateway [172.16.253.254]
SR-MGC(SP) nameserver [172.16.253.1]
SR-MGC(SP) hostname [srmgc-sp]
SR-MGC(SP) SIP-ID [1]
SR-MGC(SP) MPH-ID [1]
SR-MGC(TP) IP address [172.16.253.0]
SR-MGC(TP) Drs Port Number [3456]
SR-MGC(SP) Standard SIP terminal TimeZone
[Tokyo Standard Time]
Type the IP address of SR S.
Type "SV7000" for login account.
Type "SV7000" for password.
Take note that the entered password is not displayed.
When login is successful, display will be as shown on the left.
Type the command on the left.
Type "SV7000" for password.
Current Data are listed.
Default values for each parameters are displayed
in brackets ([ ]).
The current setting for Standard SIP terminal
TimeZone data.
VOL.2-2194
SR-MGC
Program→ Accessory →
→