NEC Univerge sv8500 Manual page 2898

D
STEP 15: Press Save key to save the data change.
After saving the data, the configuration data assignment is complete.
END
By pressing Cancel Key at this time, all assigned data is discarded returning to the previous setting.
Note:
When STEP 15 is performed, the IP Enabled Dterm starts setup process with the DRS on the same network. If
data assignment is not proper, an error message is displayed. In this case, correct the data assignment.
CHAPTER 4
[User Menu]
1. DHCP Mode
2. DRS Address Primary
Up Down Cancel Save
VOL.3-411
CONFIGURATION SETUP