NEC Univerge sv8500 Manual page 3149

[2] Configuration Setting by Web Programming
STEP 1: Select [Maintenance]
STEP 2: Clicking the "OK" button will return all the parameters to factory default settings.
STEP 3: Select [Network Settings]
STEP 4: Select "1. Disable" radio button (DHCP is disabled). Click the "OK" button.
STEP 5: Select [Network Settings]
STEP 6: Enter the IP address of the DT700 Series terminal. Click the "OK" button.
STEP 7: Select [Network Settings]
STEP 8: Enter the IP address of default gateway (router). Click the "OK" button.
STEP 9: Select [Network Settings]
STEP 10: Enter subnet mask. Click the "OK" button.
STEP 11: Depending on the way to specify SIP server, perform either of the following:
a. When SIP server is specified by IP address:
b. When SIP server is specified by FQDN:
Assign DNS server's IP address on DT700 Series configuration setting.
Note:
STEP 12: Select [Network Settings]
STEP 13: Enter the IP address of DNS server. Click the "OK" button.
STEP 14: Select [SIP Settings]
a. To specify SIP server by IP address:
Assign the IP address of SIP server, and then click the "OK" button.
b. To specify SIP server by FQDN:
Assign fully qualified domain name of SIP server, and then click the "OK" button. 0-9, A-Z, a-z, *,
#, . (period), - (hyphen), and _(underscore) is available to use for domain name entry (maximum
128 characters).
DNS server's assignment is necessary when using fully qualified domain name. See "IP Address Setting for
Note:
DNS Server" for details.
About IP address of SIP server (Telephony Server), refer to "Registration Destination of IP Devices/Sta-
Note 1:
tions" in INTRODUCTION of Installation Manual.
STEP 15: If there are backup SIP servers in the network, continue assigning 2nd, 3rd and 4th SIP server.
- Click [2nd Server Address] to assign the second SIP server.
- Click [3rd Server Address] to assign the third SIP server.
- Click [4th Server Address] to assign the fourth SIP server.
STEP 16: As in STEP 8, specify the SIP server by IP address or FQDN. Click the "OK" button after assigning
the data.
STEP 17: Click the "Save" button. After setting is complete, SIP server begins setup for DT700 Series.
→ [Data Clear] → [Factory Value].
→ [DHCP Mode].
→ [IP Address].
→ [Default Gateway].
→ [Subnet Mask].
→
→ [DNS Address].
→ [Server Address & URI]
VOL.3-662
CHAPTER 4
→ Go to STEP 14.
Go to STEP 12.
→ [1st Server Address].
CONFIGURATION SETUP
Note 1