NEC Univerge sv8500 Manual page 3148

F
STEP 27: On [Server Address] menu, press the software key for "Exit" to return to [SIP Settings] menu.
[Server Address]
1.1st Server Address
2.2nd Server Address
3.3rd Server Address
STEP 28: On [SIP Settings] menu, press the software key for "Exit" to return to [Config] menu.
[SIP Settings]
1.SIP User
2.Server Address
3.Access Mode
STEP 29: On [Config] screen, press the software key "Save" to save the settings. SIP server begins setup
for DT700 Series.
[Config]
1.Network Settings
2.SIP Settings
3.Maintenance Settings
Cancel Save
Note: In the following instances, the terminal will display an error message.
- SIP server does not exist in the network
- Connection to SIP server could not be established since the user assigned an incorrect value.
- Connection to DHCP Server could not be established since the user assigned an incorrect value.
If the above occurs, perform one of the following:
- Reassign data settings
- Connect SIP server to the network.
- Connect DHCP Server to the network.
Refer to "Error Messages" for details on error messages.
END
Exit
Exit
VOL.3-661
CHAPTER 4 CONFIGURATION SETUP