NEC Univerge sv8500 Manual page 2998

(b) Press the SRC key. The display returns to the fourth page of the Configuration Menu.
(c) To assign data to additional configuration items, refer to the Selecting a Configuration Item section.
When finished, proceed to the Updating the Configuration Data section.
10. RINGING
This item specifies the On/Off setting of the Ringing function.
(a) Press the desired number. An asterisk (*) shows the selected number.
1. Ringing is available
2. Ringing is not available
SRC Return to the Configuration Menu
The default setting is "1: ENABLE".
Note 1:
(b) Press the SRC key. The display returns to the fourth page of the Configuration Menu.
(c) To assign data to additional configuration items, refer to the Selecting a Configuration Item section.
When finished, proceed to the Updating the Configuration Data section.
[CONFIG MENU P4]VER x
1: 2ND RINGING
2: RINGING
3: RECEIVER VOLUME SET
[2ND RINGING]
*1: ENABLE
Note 1
2: DISABLE
[CONFIG MENU P4]VER x
1: 2ND RINGING
2: RINGING
3: RECEIVER VOLUME SET
CHAPTER 4
SRC: menu
DEST: next page
Release: exit
Answer: update
SRC: menu
SRC: prev page
DEST: next page
Release: exit
Answer: update
VOL.3-511
CONFIGURATION SETUP