6.2.12.2 Using Supplicant Mode
This section explains the procedure to connect a PC with supplicant feature to the PC port of DT700 Series.
1
PC to be connected to PC port of DT700 series requires the following Operating System (OS):
Note 1:
• Microsoft ® Windows 2000 ®
• Microsoft ® Windows XP ®
[1] Configuration Setting on Terminal
STEP 1: On [Config] menu, select "1. Network Settings."
[Config]
1.Network Settings
2.SIP Settings
3.Maintenance Settings
STEP 2: The LCD displays [Network Settings] menu. Select "6. Advanced Settings."
[Network Settings]
4.Subnet Mask
5.DNS Address
6.Advanced Settings
STEP 3: On [Advanced Settings] menu, select "2. PC Port Settings."
[Advanced Settings]
1.LAN Port Settings
2.PC Port Settings
3.CDP Mode
STEP 4: The LCD displays [PC Port Settings] menu. Select "6. EAPOL Forwarding."
[PC Port Settings]
4.Port VLAN Priority
5.Port Available
6.EAPOL Forwarding
A
Service Pack 4 or later
with
Service Pack 2 or later
with
Note: For other operations, " ↑" and " ↓" of software key,
Cancel Save
Up
Exit
Down
Exit
Exit
CHAPTER 4
cursor key, and touch-sensitive panel operation are
also available. Refer to Section 6.1.1.2 Operations for
more details.
Network Settings Menu List
1. DHCP Mode
2. IP Address
3. Default Gateway
4. Subnet Mask
5. DNS Address
6. Advanced Settings
VOL.3-696
CONFIGURATION SETUP
Note