NEC Univerge sv8500 Manual page 2521

Caution: BEFRORE STARTING THE INSTALL, REMOVE THE LINE CORD AND THE AC ADAPTER FROM
term
THE D MAIN UNIT.
(1) Press the two hooks of the base mold.
tilt leg
base mold
term
D Series i
(3) Remove the base mold from the main unit.
base mold
main unit
(5) Insert the upper hooks to the main unit so
that the adapter may be firmly locked.
1 2
Make sure that SW1 on the
1 2
IP adapter is set to 2.
SW 1
When the IP Enabled Dterm is connected to "Catalyst PRW series of CISCO/POWER PATCH PANEL
Note:
of CISCO," leave the switch to the default (2). Otherwise set it to 1.
How to Install IP Interface Adapter (Dterm Series i)
hook
VOL.3-34
(2) Slide the base mold to forward by pressing the hooks.
(4) Insert the lower hooks of the adapter to the unit.
IP Interface
adapter
(6) Mount the base mold again on to the unit.
Remove the covers.
base mold
CHAPTER 1 TERMINALS