NEC Univerge sv8500 Manual page 2908

1.3 DtermIP/IP Enabled Dterm Data Assignment for System without DHCP Server - Type 3
The following shows the procedure of DtermIP/IP Enabled Dterm data assignment for a system having no
DHCP server.
Caution: Observe the following while performing this procedure:
• Do Not Turn OFF the power of the DtermIP/IP Enabled Dterm, the Telephony Server, DHCP
server.
• Do Not Unplug or Plug the LAN cable connecting to the DtermIP/IP Enabled Dterm, the
Telephony Server, DHCP.
• Do Not Turn OFF the power of the HUB connecting to the DtermIP/IP Enabled Dterm, the
Telephony Server, DHCP.
STEP 1: Turn ON the DtermIP/IP Enabled Dterm.
Ex.)
Note: If any data has been assigned to the terminal, the displayed message may differ from the above.
Note: When using Backup DRS, "DRS(2nd) Connecting...", "DRS(3rd) Connecting...", or "DRS(4th) Connecting..."
will be displayed instead of "DRS(1st) Connecting...".
STEP 2: While indicating "DHCP Connecting..." or "DRS(1st) Connecting on the display,
press "Hold" + "Transfer" + "*" + "#" on the terminal, and open the User Menu.
Two items are displayed on the terminal at a time.
STEP 3: Open the Administrator Menu by pressing "Hold" + "#" + "0" on the User Menu.
The following Administrator Menu is displayed.
A
DHCP Connecting...
[User Menu]
1. DHCP Mode
2. DRS Address Primary
Up Down Cancel Save
[Administrator Menu]
1. DtermIP Mode
2. Download Address
Up Down Exit
VOL.3-421
CHAPTER 4
DRS(1st) Connecting...
or
Administrator Menu List
1. DtermIP Mode
2. Download Address
3. Area ID
4. Port
Up
5. Download
6. SoftReset
7. Factory Value
8. Type of Service
9. Language
Down
0. Next Page (P1 >> P2)
CONFIGURATION SETUP