NEC Univerge sv8500 Manual page 3224

TLV
Firmware Revision TLV
Software Revision TLV
Serial Number TLV
Manufacturer Name
Model Name
Asset ID
[Conditions for LLDP Auto Setting]
(1) To enable the LLDP Auto Setting Mode, an LLDP packet needs to contain a Network Policy TLV with
Unknown Policy Flag (U) set to "0." If more than one Network Policy TLV is contained in a LLDP packet,
all of their Unknown Policy Flag (U) must be "0."
(2) Both LLDP and LLDP Auto Setting Modes need to be enabled.
(3) DT700 Series will wait until it receives a valid LLDP packet for the LLDP Auto Setting or the Reception
Waiting Time (RX Waiting Time) has timed out. In the latter case, the LLDP Auto Setting will not be per-
formed. When receiving an LLDP packet with partially valid data, DT700 Series will continue waiting until
it receives the one having all valid information for the LLDP Auto Setting. If no LLDP packets containing
all valid data are received within the Reception Waiting Time (RX Waiting Time), the LLDP Auto Setting
will be made by using LLDP packets with partially valid data.
Received LLDP Packet
Packet containing all valid data
Packet containing partially valid
data
Packet containing no valid data
(4) The following settings can be automatically configured by the LLDP Auto Setting:
• LAN port configuration/VLAN ID
• LAN port configuration/VLAN priority
• TOS mode/RTP
• TOS mode/SIP
Received LLDP TLV
Description
Firmware version
Software version
Serial number
Manufacturer name
Model name
Asset ID (Property ID)
Criteria for the LLDP Auto Setting
Waiting for Valid LLDP
Packet (RX Waiting Time)
Ends
Continues
Continues
VOL.3-737
CHAPTER 4
Received Data
Availability
Receivable
Receivable
Receivable
Receivable
Receivable
Receivable
Performed
Performed by using only valid data after the Re-
ception Waiting Time (RX Waiting Time) is ex-
pired
Not performed
CONFIGURATION SETUP
Online Monitoring
Not viewed
Not viewed
Not viewed
Viewed
Viewed
Viewed
Auto Setting