NEC Univerge sv8500 Manual page 3012

SIP Settings
(3 of 3)
Parameter
1. Retransmit Interval
1. Standard
2. 6 seconds
2. Keeping Call
1. Disable
2. Enable
3. Howler Tone
4. Language Pattern
1. Automatic
2. Pattern 1
3. Pattern 2
About IP address of SIP server (Telephony Server), refer to "Registration Destination of IP Devices/Sta-
Note 1:
tions" in INTRODUCTION of Installation Manual.
For DtermIP (SIP) with Firmware Version 2.0.4.0 or later. Do not set this parameter except when using
Note 2:
Firewall NAT accommodating special SIP-NAT.
For DtermIP (SIP) with Firmware Version 4.1.x.x or later.
Note 3:
The setting should be "1. Disable" (fixed).
Note 4:
CHAPTER 4
Select Retransmit Interval of REGISTER and SUBSCRIBE
message during the registration process.
SIP Standard Retransmit Interval is used.
(500ms,1s,2s,4s,4s,4s,4s,4s,500ms)
Original Retransmit Interval is used. (6s,6s,6s,6s,6s,2s)
Set whether call connection is kept up even if DtermIP(SIP)
detects that communication failure occurs between the system
and DtermIP(SIP).
Call connection is not kept up even if DtermIP(SIP) detects that
communication failure occurs between the system and
DtermIP(SIP).
Call connection is kept up even if DtermIP(SIP) detects that
communication failure occurs between the system and
DtermIP(SIP).
* Not Supported.
Note 4
Select Language Pattern for day of the week and month display
on DtermIP(SIP).
Day of the week and month is displayed according to Language
Pattern instructed by system.
Day of the week and month is displayed with Display Format
Pattern 1 (Standard).
Day of the week and month is displayed with Display Format
Pattern 2 (For Europe).
VOL.3-525
CONFIGURATION SETUP
Description