NEC Univerge sv8500 Manual page 2907

D
STEP 18: Enter the IP Address of the Default Gateway when a default gateway is used.
When the IP address is entered, press "OK" key to confirm your entry. By pressing "OK" key,
the display returns to the User Menu. "OK" key entry while the data input is incomplete will be ignored.
To stop data entry, press "Cancel" key
Adr? XXX.XXX.XXX.XXX
'*' For .
BK
STEP 19: Select "6. Subnet Mask" on the User Menu by pressing "6" when a subnet mask is used.
STEP 20: Enter the subnet mask data when a subnet mask is used.
When the IP address is entered, press "OK" key to confirm your entry. By pressing "OK" key,
the display returns to the User Menu. "OK" key entry while the data input is incomplete will be ignored.
To stop data entry, press "Cancel" key
Adr? XXX.XXX.XXX.XXX
'*' For .
BK
STEP 21: Press Save key to save the data change.
When the data saving ends successfully, configuration data assignment is complete.
Note: By pressing Cancel key at this time, all assigned data is discarded returning to the previous setting.
Note: At this time, if the IP addresses of the terminal and the Default Gateway belong to different segments,
the user cannot exist from the Configuration Mode.
END
Note: The same address is to be set to the DHCP server.
Cancel OK
User Menu
6. Subnet Mask
7. DNS
Up Down Cancel Save
Note: "0.0.0.0" or "255.255.255.255" cannot be entered.
Note: The same address is to be set to the DHCP server.
Cancel OK
User Menu
1. DHCP Mode
2. DRS Address Primary
Up Down Cancel Save
VOL.3-420
CHAPTER 4 CONFIGURATION SETUP