NEC Univerge sv8500 Manual page 3079

4.4.3 Factory Value
On the Factory Value parameters, reset the terminal to its factory defaults.
STEP 1: Select "3. Factory Value" by pressing "3" key on the Maintenance Settings Menu.
"6. Auto Config" is not supported by DtermIP (SIP) with Firmware Version 4.1.x.x.
Note:
STEP 2: Press OK key to reset the terminal to its factory defaults.
After resetting the terminal to its factory defaults, new data is saved when Save key is pressed on the Main
Note:
Menu.
Maintenance Settings Menu
41.Download Menu
2.Hard Reset
3.Factory Value
4.Simple Test Mode
5.Config Password Mode
6.Auto Config
Up Down
Factory Value Set?
Cancel
VOL.3-592
CHAPTER 4 CONFIGURATION SETUP
Exit
OK