NEC Univerge sv8500 Manual page 2925

(a) 1. Speed & Duplex (PC)
The display changes as follows when "1. Speed & Duplex (PC)" is selected.
Choose a desired LAN speed by pressing each digit key, and then press OK key.
1. Autonego: Auto-Negotiation (Default)
2. 100M Full: Fixed to 100 Mbps and Full Duplex mode.
3. 100M Half: Fixed to 100 Mbps and Half Duplex mode.
4. 10M Full: Fixed to 10 Mbps and Full Duplex mode.
5. 10M Half: Fixed to 10 Mbps and Half Duplex mode.
(b) 2. VLAN Mode (PC)
The display changes as follows when "2. VLAN Mode (PC)" is selected.
Determine whether VLAN is enabled or disabled by pressing each digit key, and then press OK key.
1. Disable:
2. Enable:
(c) 3. VLAN ID (PC)
The display changes as follows when "3. VLAN ID (PC)" is selected.
Set VLAN ID in the range from 0 to 4094 (The default value is 7.), and the press OK key.
Pressing any key other than 0 to 9 is invalid.
Note:
To delete an entered character, press BK key.
1.Autonego
2.100M Full
Up Down
1.Disable
2.Enable
PC Port VLAN is disabled. (Default)
PC Port VLAN is enabled.
ID
(0-4094)
BK
VOL.3-438
CHAPTER 4
Cancel OK
Cancel OK
XXXX
Cancel OK
CONFIGURATION SETUP