NEC Univerge sv8500 Manual page 2518

2. IP Enabled Dterm
2.1 General
IP Enabled Dterm is a Dterm that is equipped with IP interface adapter (OPTION). Available Dterm is Dterm
Series i and Dterm Series E/Dterm 75. By using IP interface adapter, Dterm can be used as an IP terminal. The
following hardware is used:
• Dterm Series i, Dterm Series E/Dterm 75
• IP Interface Adapter
• AC Power Adapter
IP Enabled Dterm
(Dterm Series E/Dterm 75)
Dterm Series E/
Dterm 75
2.2 Installation Procedure
Follow the procedure below to install the IP Enabled Dterm.
STEP 1: Attach the IP Interface Adapter to the Dterm. (Refer to 2.3How to Install IP Interface Adapter.)
STEP 2: Prepare LAN cable (10BASE-T/100BASE-TX straight-through) for connecting the IP Enabled Dterm
to network device such as PoE Switch.
STEP 3: Connect the IP Enabled Dterm to the network device using the LAN cable.
STEP 4: Connect a PC to the IP Enabled Dterm if required.
STEP 5: Connect the AC/DC adapter to the IP Enabled Dterm. (When powered HUB (PoE switch) is used, skip
this step. For more information about the powered HUB (PoE switch), refer to
STEP 6: Set the configuration data of the IP Enabled Dterm. (See Appendix for configuration data setting.)
IP Enabled Dterm
for PC
to LAN
LAN Cable
AC-DC
Dterm Series i
IP Interface
Adapter
VOL.3-31
CHAPTER 1
IP Enabled Dterm
(Dterm Series i)
IP Interface
Adapter
APPENDIX
TERMINALS
LAN Cable
AC-DC
A.)