NEC Univerge sv8500 Manual page 2341

To confirm that shutdown is complete, check the PWR lamp. When the auto-shutdown does not work,
Note 3:
press and hold the CPU PWR switch for four seconds to turn off the power forcibly.
If you want to operate an SR-MGC(E) with off-line mode, turn it on with the MODE switch set to on.
Note 4:
If you activate an SR-MGC(E) with off-line mode, the following settings apply:
• SR-MGC(E) is set up without running TP and SP programs.
• An Ether1 IP address comes to 192.168.0.2/24.
Connect the Telephony Server Maintenance Menu/PCPro Tools (
tain the SR-MGC(E). But Telephony Server Maintenance Menu/PCPro Tools may not be available de-
pending on the system state.
Telephony Server Maintenance Menu is available since FP85-109 S6. For FP85-108 S5 or earlier, use
Note 5:
only PCPro tools.
Do not connect any cable to the Ether2, Ether3, and Ether4 connectors.
Note 6:
(3) Rear panel
Part
PWR switch
AC power inlet
PWR alarm lamp
FAN1 alarm lamp
FAN2 alarm lamp
Cooling FAN1
Cooling FAN2
Condition
- Hold down "O" to turn off.
- Hold down "l" to turn on.
Connected with an attached three-polar
- grounded AC power cable
(Cable Length: 3 m [9.8 ft.])
ON (red) Failure in power.
OFF Works properly.
ON (red) FAN1 fails.
OFF FAN1 works.
ON (red) FAN2 fails.
OFF FAN2 works.
- A FAN for cooling the device.
- A FAN for cooling the device.
VOL.2-2088
) to Ether1 so that you can main-
Note 5
Description
SR-MGC(E)
Remarks
Fix the cable with
the stopper to pre-
vent it from falling
out.
Replaceable during
operation.
Replaceable during
operation.