NEC Univerge sv8500 Manual page 3029

STEP 2: Advanced Settings Menu appears. Select "3. CDP Mode" by pressing "3" key on the Advanced
Settings Menu.
STEP 3: Select whether to send the power consumption information to the hub. When selecting "1. Disable",
power consumption information is not sent to the hub. When selecting "2. Enable", power
consumption information is sent to the hub. CDP Mode is enabled by the default setting.
The currently enabled CDP Mode flashes.
Note:
STEP 4: After CDP Mode is set, press OK key and go back to the Advanced Settings Menu.
STEP 5: Press Exit key on the Advanced Settings Menu to return to the Network Settings Menu.
STEP 6: Press Exit key on the Network Settings Menu and go back to the Main Menu.
STEP 7: Press Save key on the Main Menu to save the assigned data.
4.1.6.4 Type of Service
On the Type of Service parameter, set the ToS of RTP and SIP.
STEP 1: Select "6. Advanced Settings" by pressing "6" key on the Network Settings Menu.
Advanced Settings Menu
161.LAN Port Settings
2.PC Port Settings
3.CDP Mode
4.Type of Service
5.802.1X Settings
Up Down Exit
1.Disable
2.Enable
Cancel
VOL.3-542
CHAPTER 4 CONFIGURATION SETUP
OK