NEC Univerge sv8500 Manual page 2571

STEP 5: Pull the latch to open the expansion connector cover as shown the figure below.
telephone connection cable
DSS console
STEP 6: Plug the other end of the telephone connection cable into the console connector on the back of the
Desktop terminal (see the figure above).
STEP 7: Coil the excess cable and place it inside the expansion connector box. Close the cover.
STEP 8: Insert the AC adapter plug to the DC input connector on the back of the DSS console.
.
STEP 9: Thread the AC adapter cable through the groove on the back of the DSS console as shown in the figure
above.
STEP 10: Perform STEPs
This completes the process of mounting the DSS console to the DT700 Series terminal.
latch
expansion connector cover
DC input connector
AC adapter cable
groove
10 to 14 described in
console connector
AC adapter plug
[1]Connecting the DSS console to the DT300 Series
VOL.3-84
CHAPTER 1
Desktop terminal
DSS console
TERMINALS
Terminal.