NEC Univerge sv8500 Manual page 2434

<Data Assignment on SR-MGC>
This item explains the procedures for setting up SR-MGC. Log in to SR-MGC by PCPro.
[1] Use the AIPA command
Assign the network data such as IP address of SR T.
<IP Address Settings>
IP Address: Specify the IP address of SR T.
Net Mask: Enter the subnet mask.
Default GW IP Address: Enter the IP address of router in the network that SR-MGC belongs to.
MGC IP Address: Enter the IP address of LAN1 (ACT) as Telephony Server (MGC)'s address.
<NIC Settings>
Speed: Select the speed. [10M/100/Auto(default)]
Duplex Mode: Select the mode if 10 or 100Mbps is selected in Speed.
<Office Data Copy Settings>
FTP Login Name: Specify the login name assigned at the Telephony Server (MGC) side.
FTP Login Password: Specify the password assigned at the Telephony Server (MGC) side.
[2] Use the MEM_HDD command
Assign the office data backup to the Flash card in the SR-MGC. Select "SR-MGC" alone in the Data Type
Select to back up the data.
[3] Turn off and on to reset the SR-MGC
After all the settings are completed, reboot the SR-MGC to apply the new settings. SR-MGC will be acti-
vated with the new IP Address assigned in [1].
[4] Copy Office Data by using the CMNT command
Log in to the Telephony Server (MGC) by PCPro and copy Office Data from the Telephony Server (MGC)
to SR-MGC. Do not turn off the power of the SR-MGC during the Office Data copy.
PCPro SR-MGC
VOL.2-2181
SR-MGC
,
Note 1 Note 2