NEC Univerge sv8500 Manual page 2897

C
STEP 11: Select "3. BackUp-DRS Address" and display Backup-DRS Selection Menu.
This setting is required only when Redundancy Configuration Systems (such as SR-MGC) are
connected on the network. If there is no Redundancy Configuration System on the network,
go to STEP 15.
STEP 12: Select a desired Redundancy Configuration System and assign its IP address.
IP addresses of a maximum of three Redundancy Configuration Systems can be set here.
STEP 13: Press the OK Key to return to the Backup-DRS Selection Menu.
STEP 14: After all the necessary IP addresses are set, press the Exit Key to return to the User Menu.
D
[User Menu]
2. DRS Address Primary
3. BackUp-DRS Address
UP Down Cancel Save
Backup-DRS Selection Menu
1. DRS Address 2nd
2. DRS Address 3rd
UP Down Exit
Adr? XXX.XXX.XXX.XXX
'*' For .
BK Cancel OK
Backup-DRS Selection Menu
1. DRS Address 2nd
2. DRS Address 3rd
UP Down Exit
VOL.3-410
CHAPTER 4 CONFIGURATION SETUP
User Menu List
Up
1. DHCP Mode
2. DRS Address Primary
3. BackUp-DRS Address
4. IP Address
5. Default Gateway
Down 6. Subnet Mask
7. DNS
8. Ether Port Settings
9. System Information
Up Down Cancel Save
Up
Backup-DRS Menu List
1. DRS Address 2nd
2. DRS Address 3rd
3. DRS Address 4th
Down