NEC Univerge sv8500 Manual page 2999

11. RECEIVER VOLUME SET
This item specifies the receiver volume.
(a) Press the desired number. An asterisk (*) shows the selected number.
1. Receiver volume is set to the default level of the ATI card
2. Receiver volume is set to the level in accordance with the system default
3. Receiver volume is set to the level adjusted by the UP/DOWN key
4. Receiver volume is set to the level (-8dB) lower than the System Default
SRC Return to the Configuration Menu
Default setting is "1: SYSTEM DEFAULT".
Note 1:
(b) Press the SRC key. The display returns to Configuration Menu.
(c) When configuration data assignment is completed, proceed to UPDATING CONFIGURATION
DATA. When the other item is also specified, return to SELECTION OF CONFIGURATION ITEM.
[RECEIVER VOLUME SET]
*1: SYSTEM DEFAULT
2: DEFAULT BY CALL
3: SAME AS PREVIOUS CALL
[CONFIG MENU P4] VER x
1: 2ND RINGING
2: RINGING
3: RECEIVER VOLUME SET
CHAPTER 4
SRC: menu
4: QUIET PLACE
Note 1
SRC: prev page
DEST: next page
Release: exit
Answer: update
VOL.3-512
CONFIGURATION SETUP