NEC Univerge sv8500 Manual page 2899

1.2.1 Setting for Redundancy Configuration System
The following procedure explains how to use the previous IP address (obtained through the DHCP server) as an
alternative when DtermIP/IP Enabled Dterm failed to connect to the DHCP server.
STEP 1: Turn ON the DtermIP/IP Enabled Dterm.
Wait for a while until the following message is displayed on the terminal.
Ex.)
Note: If any data has been assigned to the terminal, the displayed message may differ from the above.
STEP 2: While indicating "Connecting..." or "DRS(1st) Connecting" on the display, press "Hold" +
"Transfer" + "*" + "#" on the terminal, and open the User Menu.
STEP 3: Open the Administrator Menu by pressing "Hold" + "#" + "0" on the User Menu.
The following Administrator Menu is displayed.
STEP 4: Select "7. Factory Value" by pressing "7" key on the Administrator Menu.
A
DHCP Connecting...
[User Menu]
1. DHCP Mode
2. DRS Address Primary
Up Down Cancel Save
[Administrator Menu]
1. DtermIP Mode
2. Download Address
Up Down
[Administrator Menu]
6. SoftReset
7. Factory Value
Up Down
VOL.3-412
CHAPTER 4
DRS(1st) Connecting...
or
Administrator Menu List
1. Dterm
2. Download Address
3. Area ID
4. Port
5. Download
6. SoftReset
Exit
7. Factory Value
8. Type of Service
9. Language
0. Next Page (P1 >> P2)
Exit
CONFIGURATION SETUP
IP Mode
Up
Down