NEC Univerge sv8500 Manual page 2320

2. To show Country Code:
VS-32> SHOW COUNTRYCODE
Use country is JPN. (Japan code: 0x0001)
3. To show DHCP setting:
VS-32> SHOW DHCP
DHCP is ENABLE
4. To show DNS server setting:
VS-32(SIP)> SHOW DNS_SW
DNS interface: DISABLE
DNS IP Address: 10.41.1.150
5. To show IP address and port number of DRS:
This command shows the DRS's IP address and port number setting on VS-32(Dual) (for Proprietary Pro-
tocol mode only).
About IP address of DRS (Telephony Server), refer to "Registration Destination of IP Devices/Stations" in
Note:
INTRODUCTION of Installation Manual.
• When P1=1 is entered specifying the Primary DRS to read out:
VS-32> SHOW DRSADDRESS P1
Primary DRS Address 10.41.1.100, Port 3456
• When P1entering is skipped to show all the DRSs' setting:
VS-32> SHOW DRSADDRESS
Primary DRS Address 10.41.1.100, Port 3456
Secondary DRS Address 10.41.1.101, Port 3456
Tertiary DRS Address 10.41.1.102, Port 3456
Fourth DRS ADdress 10.41.1.103, Port 3456
6. To show ToS setting for DRS session:
VS-32> SHOW DRSTOS
VS-32(Dual) [SCA-VS32VA/MG-VS32VA]
The current setting is shown.
The current setting is shown.
Used for SIP mode only.
The current setting is shown.
P1: Specify the DRS [1-4]
1=Primary/2=Secondary/3=Tertiary/4=Fourth
The current setting is shown.
The current setting for all the DRSs is shown.
(Secondary or latter DRSs are not displayed when
not assigned.)
Used for Proprietary Protocol mode only.
VOL.2-2067