NEC Univerge sv8500 Manual page 2943

1.4.11 How to Set Language for Time Display
To set language for Time Display of DtermIP/IP Enabled Dterm, follow the procedure below.
The following languages are supported by each terminal:
• IP Enabled Dterm (Dterm Series E/Dterm 75): Automatic (according to the System Data setting), English,
Portuguese, Spanish, French
• IP Enabled Dterm (Dterm Series i), DtermIP: Automatic (according to the System Data setting), English, Por-
tuguese, Spanish, French, German, Italian, Dutch, Norwegian, Danish, Swedish
STEP 1: Open the User Menu by pressing "Hold"+"Transfer"+"*"+"#" while the terminal is in normal operation,
indicating an error message or "DHCP Connecting.../DRS(1st) Connecting..." on the display.
Two items are displayed on the terminal.
Note: When using Backup DRS, "DRS(2nd) Connecting...", "DRS(3rd) Connecting...", or "DRS(4th) Connecting..."
will be displayed instead of "DRS(1st) Connecting...".
STEP 2: Open the Administrator Menu by pressing "Hold"+"#"+"0" on the User Menu.
The following Administrator Menu is displayed.
STEP 3: Select "9. Language" by pressing "9" on the menu. The display changes as follows.
A
CHAPTER 4
[User Menu]
1. DHCP Mode
2. DRS Address Primary
Up Down
Cancel Save
[Administrator Menu]
1. DtermIP Mode
2. Download Address
Up Down
Exit
*. Automatic
0. English/Japan
Up Down Cancel OK
VOL.3-456
CONFIGURATION SETUP
Administrator Menu List
1. DtermIP Mode
2. Download Address
3. Area ID
4. Port
5. Download
Up
6. SoftReset
7. Factory Value
8. Type of Service
9. Language
0. Next Page (P1 >> P2)
Down
Language Items
*. Automatic
0. English/Japan
Up
1. Portuguese
2. Spanish
3. French
4. German
Down
5. Italian
6. Dutch
7. Norwegian
8. Danish
9. Swedish