NEC Univerge sv8500 Manual page 3134

6.2.1.2 Type 2 - System with DHCP Server (SIP Server's IP Address Is Not Assigned by DHCP
Server)
This section explains the procedure of DT700 Series data assignment for a system with DHCP server and SIP
server's IP address (or FQDN) is NOT assigned on the DHCP server yet. SIP server's IP address (or FQDN) is
the only item necessary to be assigned on the configuration setting of DT700 Series.
Caution: Observe the following while assigning the configuration data:
• Do Not Turn OFF the power of the DT700 Series, SIP server, DHCP server.
• Do Not Unplug or Plug the LAN cable connecting to the DT700 Series, SIP server, DHCP.
• Do Not Turn OFF the power of the HUB connecting to the DT700 Series, SIP server, DHCP.
[1] Configuration Setting on Terminal
STEP 1: On [Config] main menu, select "3. Maintenance Settings."
[Config]
1.Network Settings
2.SIP Settings
3.Maintenance Settings
STEP 2: On [Maintenance] menu, select "3. Data Clear."
[Maintenance]
1.Download Menu
2.Hard Reset
3.Data Clear
STEP 3: On [Data Clear] menu, select "1. Factory Value."
[Data Clear]
1.Factory Value
2.Terminal Data
3.Personal Data
STEP 4: On [Factory Value] screen, press the software key for "OK."
[Factory Value]
Factory Value Set?
A
Note: For other operations, " ↑" and " ↓" of software key,
cursor key, and touch-sensitive panel operation are
also available. Refer to Section 6.1.1.2 Operations for
Cancel Save
more details.
Exit
Exit
Cancel OK
VOL.3-647
CHAPTER 4 CONFIGURATION SETUP