A
STEP 5: "Factory Value Set?" is displayed. Press OK key.
By pressing the OK key, the display automatically returns to the Administrator Menu.
On the Administrator Menu, press Exit key to return to the User Menu.
STEP 6: Select "DHCP Mode" by pressing "1" key on the User Menu.
STEP 7: Select "Enable (w/ Spare IP)" by pressing "3" key.
STEP 8: Enter an alternative IP address. Then press OK key to return to the previous display.
"OK" key entry while the data input is ignored. To stop data entry, press "Cancel" key.
B
Factory Value Set?
Cancel
OK
[User Menu]
1. DHCP Mode
2. DRS Address Primary
Up
Down Cancel Save
2. Enable
3. Enable (w/ Spare IP)
Cancel OK
Up Down
Adr? XXX.XXX.XXX.XXX
'*' For .
BK
Cancel
VOL.3-403
CHAPTER 4
CONFIGURATION SETUP
Up
1. Disable
2. Enable
3. Enable (w/ Spare IP)
4. Enable (Auto BackUp)
Down
Up Down Cancel Save
OK