NEC Univerge sv8500 Manual page 2278

• When DHCP server is used and DNS server is NOT used
In this setting, because IP addresses are automatically distributed from DHCP server, it is not required to
set IP address on VS-32(Dual) side. Set the following data on VS-32(Dual):
• Communication Speed of LAN Interface
IP addresses listed below, however, need to be assigned on DHCP server side.
• IP address of Default Gateway
• IP address of SIP server
Check the number of IP addresses stored in DHCP server is sufficient so as to get IP address of VS-32(Du-
Note 1:
al) anytime.
Assign the required DHCP option in Add Option Type dialog box as follows:
Note 2:
Class:
Name:
Data:
Array:
Code:
IP address of Default Gateway
IP address or host name of SIP server
IP address of the Telephony Server
Refer to DHCP Server in Volume 2 of this manual for more information on DHCP option setting.
About IP address of SIP server (Telephony Server), refer to "Registration Destination of IP Devices/Sta-
Note 3:
tions" in INTRODUCTION of Installation Manual.
Note 3
Global
Not specified, but do not enter the same option name in duplicate (e.g. SP1)
IP address
Checked
See the table below.
OPTION NAME
VS-32(Dual) [SCA-VS32VA/MG-VS32VA]
CODE
003 Required when DHCP server is active.
120
Either code 120 or 162 is required. Code 120
turns invalid when code 162 is assigned.
162
VOL.2-2025
,
Note 1 Note 2
REMARKS