NEC Univerge sv8500 Manual page 3239

6.2.22.2 How to Set the Substitute IP Address
STEP 1: On [Config] menu, select "1. Network Settings."
[Config]
1.Network Settings
2.SIP Settings
3.Maintenance Settings
Cancel Save
STEP 2: The LCD displays [Network Settings] menu. Select "6. Advanced Settings."
[Network Settings]
1.DHCP Mode
2.IP Address
3.Default Gateway
STEP 3: On [Advanced Settings] menu, select "7. Spare IP Settings."
[Advanced Settings]
5.Self Port Settings
6.LLDP Settings
7.Spare IP Settings
STEP 4: The LCD displays [Spare IP Settings] screen. Select "1. Spare/Backup IP Mode."
[Spare IP Settings]
1.Spare/Backup IP Mode
2.Network Settings
3.SIP Settings
STEP 5: The LCD displays [Spare/Backup IP Mode] screen.
[
Spare/Backup IP Mode
1.Disable
2.Spare IP
3.Backup IP
Cancel
A
Exit
Exit
Exit
- Press the digit key "1" to disable the Spare/Backup IP.
]
- Press the digit key "2" to use the Spare IP.
- Press the digit key "3" to use the Backup IP.
- Press the software key for "OK" when the [Spare/Backup IP Mode]
OK
setting is complete.
Note: This data is valid when the Spare/Backup IP is disabled.
VOL.3-752
CHAPTER 4
Network Settings Menu List
1. DHCP Mode
Up
2. IP Address
3. Default Gateway
4. Subnet Mask
5. DNS Address
6. Advanced Settings
Down
CONFIGURATION SETUP