NEC Univerge sv8500 Manual page 3144

B
STEP 10: Select "1." and verify that "1. Disabled" line is flashing. Then press the software key for "OK."
[DHCP Mode]
1.Disable
2.Enable
Cancel OK
STEP 11: The LCD displays [Network Settings] menu. Select "2. IP Address" to display [IP Address] menu.
[Network Settings]
1.DHCP Mode
2.IP Address
3.Default Gateway
STEP 12: On [IP Address] setting screen, assign the IP address of DT700 Series terminal using number keys.
[IP Address]
*'For'.'
0. 0.
BK Cancel OK
STEP 13: The LCD displays [Network Settings] menu. Select "3. Default Gateway" to display [Default
Gateway] menu.
[Network Settings]
1.DHCP Mode
2.IP Address
3.Default Gateway
STEP 14: On [Default Gateway] setting screen, assign the IP address of DT700 Series terminal using
digit keys.
[IP Address]
*'For'.'
0. 0.
BK Cancel OK
C
Exit
0. 0
Use "*" to separate each bytes.
Press the software key for "OK" when all settings are complete.
Exit
0. 0
Use "*" to separate each bytes.
Press the software key for "OK" when all settings are complete.
VOL.3-657
CHAPTER 4 CONFIGURATION SETUP