NEC Univerge sv8500 Manual page 2951

1.5.2 TFTP(FTP) Server IP Address Setting
The following shows the procedure for downloading on the config menu. Before downloading, install the TFTP
(FTP) server and the DtermIP/IP Enabled Dterm on the same network
.
STEP 1: Set up the TFTP (FTP) server.
<TFTP server>
Designate the directory , where the program file is stored, as the [IP Enabled Dterm (Dterm Series E
/Dterm 75): ramhptop.hex (ramhprt.hex), IP Enabled Dterm (Dterm Series i): ramhp2pr.hex,
Dterm IP: ramhp2pw.out] directory for downloading.
Note: Do not change the file name or extension of the download program file.
<FTP server>
Place download program file [IP Enabled Dterm (Dterm E/Dterm 75): ramhptop.hex
(ramhprt.hex), IP Enabled Dterm (Dterm Series i): ramhp2pr.hex, Dterm: ramhp2pw.out]
in the appropriate directory in advance.
For Windows NT/2000 server, the default is "C:\InetPub\ftproot."
Note: Do not change the file name or extension of the download program file.
STEP 2: Enter the necessary data for operation of the terminal such as "DRS Address",
"IP Address of the terminal" and "Subnet Mask" in advance.
STEP 3: Open the User Menu by pressing "Hold" + "Transfer" + "*" + "#" on the terminal.
Two items are displayed on the terminal.
STEP 4: Open the Administrator Menu by pressing "Hold" + "#" + "0" on the User Menu.
The following Administrator Menu is displayed.
A
1. DHCP Mode
2. DRS Address Primary
Up Down Cancel Save
[Administrator Menu]
1. DtermIP Mode
2. Download Address
Up Down Exit
CHAPTER 4
[User Menu]
Up
Administrator Menu List
1. DtermIP Mode
2. Download Address
3. Area ID
4. Port
Down
5. Download
6. SoftReset
7. Factory Value
8. Type of Service
9. Language
0. Next Page (P1 >> P2)
VOL.3-464
CONFIGURATION SETUP