NEC Univerge sv8500 Manual page 2301

Setting IP Address, Port Number, and Host Name of DRS
--- DRS IP Address set ---
Current DRS Server/IP Address/Port Number:
Primary
Secondary
Tertiary
Fourth
Change DRS Information? [Y(change)/N(current)/Q(quit)]: y
Input DRS unit (1:Primary/2:Secondary/3:Tertiary/4:Fourth): 1
Input DRS IP Address: 10.41.1.200
Input DRS Port Number: 3456
Continue? [Y(continue)/N(exit)]: n
Line 3~Line 6: The current setting of DRS information (IP address and port number) is
displayed.
Line 7: Asked whether to change the displayed setting.
Y=change
N=not change
Q=quit this setting
Line 8: Enter the number of DRS [1-4]
Line 9: Enter the IP address of DRS (e.g. 10.41.1.200) Note 1
Line 10: Enter the port number of DRS (default=3456)
Line 11: Asked whether to continue the setting of other DRSs.
Y=Continue to register other DRSs
N=Exit this setting and move on to the next step
This setting is required when DHCP server is "D (disable)".
Note:
About IP address of DRS (Telephony Server), refer to "Registration Destination of IP Devices/Stations" in
Note 1:
INTRODUCTION of Installation Manual.
DRS Address 0.0.0.0
DRS Address 0.0.0.0
DRS Address 0.0.0.0
DRS Address 0.0.0.0
VOL.2-2048
VS-32(Dual) [SCA-VS32VA/MG-VS32VA]
, Port 3456
, Port 3456
, Port 3456
, Port 3456