NEC Univerge sv8500 Manual page 2970

ERROR MESSAGES
IP Enabled Dterm double assignment
Double Assignment
Exit
Illegal Line Equipment Number
Illegal LEN
Exit
PH cannot hunted
PH Unavailable
Exit
Registration Module Cannot Recognize
Equipment Type
Illegal Equipment Type
Exit
Configuration data duplicate in Port Num-
ber is downloaded or registered.
Port Number Duplicate
Error Messages of IP Enabled Dterm (2/4)
MEANING
"Double Assignment" was received
from DRS, after sending "initial setup
request" from the IP Enabled Dterm.
(From this indication, configuration
display can be shown by the ordinary
configuration data assignment opera-
tion.)
"Illegal LEN" was received from the
DRS, after sending "initial setup re-
quest" from the IP Enabled Dterm.
(From this indication, configuration
display can be shown by the ordinary
configuration data assignment opera-
tion.)
IP Enabled Dterm cannot hunted the
proper PH, after sending "initial setup
request" from the IP Enabled Dterm.
(From this indication, configuration
display can be shown by the ordinary
configuration data assignment opera-
tion.)
Registration Module cannot recognize
the equipment type message received
from the IP Enabled Dterm.
(From this indication, configuration
display can be shown by the ordinary
configuration data assignment
operation.)
IP Enabled Dterm doesn't work be-
cause duplicate port numbers are as-
signed to the DRS Self Port, Protims
Self Port, RTP Self Port and Voice
Control Port.
VOL.3-483
CHAPTER 4 CONFIGURATION SETUP
ACTION
• Change the data assigned at the
System.
• Change the LENS of the
IP Enabled Dterm at the System.
• Investigate the reason why the
PH cannot be used.
• Ask System maintenance per-
sonnel for the reason why PH
cannot be used.
• Reset the Telephony Server.
• Assign a unique port number to the
DRS Self Port, Protims Self Port, RT
Self Port and Voice Control Port
again, referring to "5. Charging Port
Number".