NEC Univerge sv8500 Manual page 2992

The default setting is "1: HEADSET".
Note 1:
(b) Press the SRC key. The display returns to the first page of the Configuration Menu.
(c) To assign data to additional configuration items, refer to the Selecting a Configuration Item section.
When finished, proceed to the Updating the Configuration Data section.
2. HEADSET TYPE
This item specifies the type of headset connected to the HAND H/S0 and H/S1 connector.
(a) Press the desired number. An asterisk (*) shows the selected number.
1. The type of headset is "SUPRA F53U-U03F".
2. The type of headset is "Wideband SupraPlus NC Polaris (HW251N plus A10 connector cable)" or "SU-
PRA-NC Polaris".
3. The type of Headset is "GN2200".
SRC: Return to the Configuration Menu
The default setting is "1: SUPRA NEW SIGMA".
Note 1:
(b) Press the SRC key. The display returns to the first page of the Configuration Menu.
(c) To assign data to additional configuration items, refer to the Selecting a Configuration Item section.
When finished, proceed to the Updating the Configuration Data section.
3. MUTE
This item specifies the On/Off setting of the mute function for the HAND H/S0 or H/S1 connector.
[CONFIG MENU P1] VER x
1: HEADSET/HANDSET
2: HEADSET TYPE
3: MUTE
[HEADSET TYPE]
*1: SUPRA NEW SIGMA
2: SUPRA POLARIS Series
3: GN2200 Series
[CONFIG MENU P1] VER x
1: HEADSET/HANDSET
2: HEADSET TYPE
3: MUTE
VOL.3-505
CHAPTER 4
SRC: prev page
DEST: next page
Release: exit
Answer: update
SRC: menu
Note 1
SRC: next page
DEST: next page
Release: exit
Answer: update
CONFIGURATION SETUP