NEC Univerge sv8500 Manual page 3219

(13) When the LLDP Transparent Mode is enabled, DT700 Series forwards LLDP packets between the LAN
and PC ports. In this case, the LLDP-capable device (switch) will recognize the DT700 Series terminal and
the PC connected to the terminal as its neighbor.
(14) The table below shows advertised LLDP Type Length Values:
TLV
Chassis ID TLV
Port ID TLV
Time To Live TLV
Port Description TLV
System Name TLV
System Description TLV
System Capabilities TLV
Management Address TLV
Port VLAN ID TLV
Port And Protocol VLAN
ID TLV
VLAN Name TLV
Protocol Identity TLV
Advertised LLDP TLV
TLV Element
chassis ID subtype
chassis ID
port ID subtype
port ID
time to live
port description
system name
system description
system capabilities
enabled capabilities
IEEE802.1 Extensions
IEEE802.3 Extensions
VOL.3-732
CHAPTER 4
Description
Chassis ID subtype
Chassis ID
Port ID subtype
Port ID
Length of time the LLDP
data will be valid
Port description
System name
System description
Supported LAN capabilities
(repeater hubs, routers, IP
phones, for example)
Enabled LAN capabilities
(repeater hubs, routers, IP
phones, for example)
CONFIGURATION SETUP
Transmitted Data from
the LAN Port
0x05 (Network address)
IP address
Before DHCP assignment;
"0.0.0.0"
After DHCP assignment;
the assigned address
0x03 (MAC address)
MAC address
LLDP packet transmission
interval×LLDP time to live
"LAN Port"
"NEC IP Phone"
"DT700 Series"
0x00 0x24
(Telephone, Bridge)
0x00 0x24
(Telephone, Bridge)
Not advertised
Not advertised
Not advertised
Not advertised
Not advertised