NEC Univerge sv8500 Manual page 2323

1 10.41.1.150
2 0.0.0.0
3 0.0.0.0
: :
: :
20 0.0.0.0
15. To show the status of VS-32(Dual):
When data setting cannot be executed normally and registration error occurs, use this command to check
the operating state of VS-32(Dual). See 24.4.2 Error Messages for the output information and their coun-
termeasures.
• Proprietary Protocol mode
VS-32> SHOW STATUS
Register Mode
MAC Address
Link State
Speed
Duplex
VLAN Mode
DHCP Mode
IP Address
Subnet Mask
Default Gateway
Registered Drs Name
Registered Drs Address
Registration Status
The following information is displayed for Ether connection state:
Note:
- Link:Up/Down
- Speed:100M/10M
- Duplex:Full/Half
Online or offline is informed for Registration Status. In the case of offline, the cause of registration error
Note:
is to be displayed. See Error Messages (related to registration in Proprietary Protocol mode) for the reason
and the countermeasures of registration error.
5060
5060
5060
:
:
5060
: TP
: 00:00:xx:xx:xx:xx
: Up
: 100Mbps
: Full
: Disable
: Disable
: 10.41.1.100
: 255.255.255.0
: 10.41.1.254
: Primary DRS
: 10.41.1.150
: Online
VOL.2-2070
VS-32(Dual) [SCA-VS32VA/MG-VS32VA]
The current setting is shown.
SVR1.nec.com
The current operating state is shown.