NEC Univerge sv8500 Manual page 3242

STEP 14: On [Network Settings] menu, select "4. DNS Address." Assign the DNS address using digit keys.
[DNS Address]
*'For'.'
0. 0.
BK Cancel
Note: When Backup IP is in service, this data will be overwritten by obtained DNS address if DT700
Series obtains an IP address from DHCP server. If obtained data does not have a DNS address, the
existing data is maintained.
STEP 15: The LCD displays [Network Settings] menu.
[Network Settings]
4. DNS Address
1. IP Address
2. Default Gateway
STEP 16: On [Network Settings] menu, press software key for "Exit" to go back to [Spare IP Settings] menu.
[Spare IP Settings]
1.Spare/Backup IP Mode
2.Network Settings
3.SIP Settings
STEP 17: On [Spare IP Settings] menu, select "3. SIP Settings."
[SIP Settings]
1.2nd Server Address
2.3rd Server Address
3.4th Server Address
D
- Use "*" to separate each byte.
- Press the software key for "BK" to delete the input value.
0. 0
- Press the software key for "OK" when the [DNS Address] setting
is complete.
OK
Exit
Exit
- Press the digit key "1" to Set the 2nd Server IP Address.
- Press the digit key "2" to Set the 3rd Server IP Address.
- Press the digit key "3" to Set the 4th Server IP Address.
- Press the digit key "4" to Set the 2nd Server port number.
Exit
- Press the digit key "5" to Set the 3rd Server port number.
- Press the digit key "6" to Set the 4th Server port number.
VOL.3-755
CHAPTER 4 CONFIGURATION SETUP