NEC Univerge sv8500 Manual page 3135

A
STEP 5: All the parameters return to factory default setting. On [Data Clear] menu, press the software key for
"Exit" to display [Maintenance] menu.
[Data Clear]
1.Factory Value
2.Terminal Data
3.Personal Data
STEP 6: On [Maintenance] menu, press the software key for "Exit" to return to [Config] main menu.
[Maintenance]
1.Download Menu
2.Hard Reset
3.Data Clear
STEP 7: On [Config] menu, select "1. Network Settings."
[Config]
1.Network Settings
2.SIP Settings
3.Maintenance Settings
Cancel Save
STEP 8: On [Network Settings] menu, select "1. DHCP Mode".
[Network Settings]
1.DHCP Mode
2.IP Address
3.Default Gateway
STEP 9: On [DHCP Mode] screen, verify that "2. Enable" is flashing, and then press the software key for "OK."
[DHCP Mode]
1.Disable
2.Enable
Cancel OK
B
Exit
Exit
Exit
VOL.3-648
CHAPTER 4 CONFIGURATION SETUP