NEC Univerge sv8500 Manual page 3139

E
STEP 20: On [Server Address] menu, press the software key for "Exit" to return to [SIP Settings] menu.
[Server Address]
1.1st Server Address
2.2nd Server Address
3.3rd Server Address
STEP 21: On [SIP Settings] menu, press the software key for "Exit" to return to [Config] menu.
[SIP Settings]
1.SIP User
2.Server Address
3.Access Mode
STEP 22: On [Config] screen, press the software key "Save" to save the settings. SIP server begins setup
for DT700 Series.
[Config]
1.Network Settings
2.SIP Settings
3.Maintenance Settings
Note: In the following instances, the terminal will display an error message.
- SIP server does not exist in the network
- Connection to SIP server could not be established since the user assigned an incorrect value.
- Connection to DHCP Server could not be established since the user assigned an incorrect value.
If the above occurs, perform one of the following:
- Reassign data settings
- Connect SIP server to the network.
- Connect DHCP Server to the network.
Refer to "Error Messages" for details on error messages.
END
[2] Configuration Setting by Web Programming
STEP 1: Select [Maintenance]
STEP 2: Clicking the "OK" button will return all the parameters to factory default settings.
STEP 3: Select [Network Settings]
Exit
Exit
Cancel Save
→ [Data Clear] →
→
[DHCP Mode].
VOL.3-652
CHAPTER 4
[Factory Value].
CONFIGURATION SETUP