NEC Univerge sv8500 Manual page 2292

SETUP
Basic settings for IP related data such as IP addresses, subnet mask, and DHCP used in VS-32(Dual) is assigned
by this command. This command must be executed when starting up VS-32(Dual) on the initial setting.
Assign IP network data and music source file following the setting command shown in dialog form. Be sure to
save the entered data at the end of each SETUP command.
When any abnormal data is entered, the dialog asks to enter proper data until three times. The third time
Note:
you enter illegal data, the SETUP command quits discarding all the entered data.
When you quit the SETUP command entry halfway through the setting, all the entered data is to be discard-
Note:
ed.
1. Setting basic IP data for SIP mode:
To startup SETUP SP command:
VS-32>
VS-32> SETUP SP
Setting one time password (*this setting is displayed when one time password has not been assigned yet):
No One Time Password!!
Please input a one time password
One Time Password: 123456
Erase start...
Erase OK!
Write start...
Write OK!
One time password setting succeeded.
VS-32(Dual) [SCA-VS32VA/MG-VS32VA]
Enter "SETUP SP" following the prompt.
Enter one time password (e.g. 123456).
Writing to Flash ROM is executed.
Result is shown.
VOL.2-2039