NEC Univerge sv8500 Manual page 2963

1.5.3.4 Download Failure
If the following information is displayed, the program download ended in failure. Determine the cause of the failure
referring to the table below.
No.
1 Download file exists in the specified directory?
2 The file name of the download file is correct?
3
TFTP (FTP) server Address assigned in the IP Enabled Dterm is correct?
4 The TFTP server and the IP Enabled Dterm exist on the same subnet (segment)?
The power of the IP Enabled Dterm/Telephony Server/DHCP/TFTP (FTP) server
5
is ON? The DHCP server is functioning as a server?
The LAN cable for the IP Enabled Dterm/Telephony Server/DHCP/TFTP (FTP)
6
server is securely connected?
The power of the HUB connecting to the IP Enabled Dterm/Telephony Server
7
/DHCP/TFTP (FTP) server is ON?
Perform the program download again following the instructions listed above. If the download ends in failure again,
there is a possibility that the memory of the IP Enabled Dterm is crashed. In this case, please inquire to maintenance
personnel.
Download Failure
Downloading...
Program Download Failed
Check Points
VOL.3-476
CHAPTER 4
Exit
FTP: Place the Download file in the
specified directory.
TFTP: Specify the directory having
the Download file.
Rename the file as
"ramhptop.hex (ramhprt.hex)/ramhp2pr.hex
/ramhp2pw.out .
Assign the IP address of the TFTP (FTP)
on the network.
Reconnect the TFTP server and/or the IP
Enabled Dterm on the same subnet
(segment).
Turn ON the power if the power is OFF.
Reconnect the cable.
Turn ON the power of the HUB.
CONFIGURATION SETUP
Actions