NEC Univerge sv8500 Manual page 2499

• When attaching WM-L UNIT to the wall plate:
Attach WM-L UNIT to the posts on the wall plate as shown in the figure below.
Switch box
The remainder of the procedure varies between DT300 Series and DT700 Series.
• In the case of DT300 Series: Go to the next step.
• In the case of DT700 Series: Go to Step 8 after the LAN cable is connected to the telephone. For
STEP 4: Attach the modular terminal to the wall as shown in the following figure. If the modular connector is
attached directly on the wall or the wall plate is used instead of modular terminal, skip this step.
Posts
the procedure how to connect LAN cable, refer to
Cabling.
Wall
VOL.3-12
WM-L
Modular Terminal
CHAPTER 1 TERMINALS
WM-L
1.4.3DT700 Series