NEC Univerge sv8500 Manual page 2957

1.5.3.2 Changing Program from PtoP to Protims (Program Download 2)
The following procedure is available only for IP Enabled Dterm (Dterm Series E/Dterm 75).
Note:
STEP 1: Open the User Menu by pressing "Hold"+"Transfer"+"∗"+"#" while the IP Enabled Dterm is in normal operation,
indicating an error message or "DHCP Connecting.../DRS(1st) Connecting..." on the display.
Two items are displayed on the IP Enabled Dterm.
Note: When using Backup DRS, "DRS(2nd) Connecting...", "DRS(3rd) Connecting...", or "DRS(4th) Connecting..."
will be displayed instead of "DRS(1st) Connecting...".
STEP 2: Open the Administrator Menu by pressing "Hold"+"#"+"0" on the User Menu.
The following Administrator Menu is displayed.
STEP 3: Select "5. Download" by pressing "5" on the menu. Download Menu is displayed.
STEP 4: Select "1. Program" by pressing "1" on the Download Menu. The display will change as follows.
A
[User Menu]
1. DHCP Mode
2. DRS Address Primary
Up Down Cancel Save
[Administrator Menu]
1. DtermIP Mode
2. Download Address
Up Down
Exit
[Download Menu]
1. Program
2. Config
Up Down
Exit
File: xxxxxxxxxxx. hex
TFTP Cancel FTP
VOL.3-470
CHAPTER 4 CONFIGURATION SETUP
Administrator Menu List
1. DtermIP Mode
2. Download Address
Up
3. Area ID
4. Port
5. Download
6. SoftReset
7. Factory Value
Down
8. Type of Service
9. Language
0. Next Page (P1 >> P2)
Up
Download Menu List
1. Program
2. Config
3. Input File Name
Down
4. Boot & Program
5. Music