NEC Univerge sv8500 Manual page 3155

A
STEP 6: The LCD returns to [Type of Service] screen. Press the software key for "Exit."
[Type of Service]
1.RTP
2.SIP
STEP 7: The LCD returns to [Advanced Settings] menu. Press the software key for "Exit."
[Advanced Settings]
1.LAN Port Settings
2.PC Port Settings
3.CDP Mode
STEP 8: The LCD returns to [Network Settings] menu. Press the software key for "Exit" to return to
[Config] menu.
[Network Settings]
4.Subnet Mask
5.DNS Address
6.Advanced Settings
STEP 9: On [Config] screen, press the software key "Save" to save the settings.
[Config]
1.Network Settings
2.SIP Settings
3.Maintenance Settings
END
[2] Configuration Setting by Web Programming
STEP 1: Select [Network Settings]
STEP 2: Select the packet type for setting the ToS value.
RTP: Click "RTP" to change the ToS value for sending RTP packet.
SIP: Click "SIP" to change the ToS value for SIP packet.
STEP 3: Enter any Hex value to the text box. Click the "OK" button.
STEP 4: Click the "Save" button.
Exit
Exit
Exit
Cancel Save
→ [Advance Settings]
VOL.3-668
CHAPTER 4 CONFIGURATION SETUP
→ [Type of Service].