NEC Univerge sv8500 Manual page 2451

When entry of all the list items is finished, they will be displayed as a list. Confirm the New
Data before the final registration.
(New Data List)
SR-MGC(SP) IP address =: 10.40.182.126
SR-MGC(SP) Netmask =: 255.255.255.0
SR-MGC(SP) default gateway =: 10.40.182.254
SR-MGC(SP) nameserver =: 10.40.182.124
SR-MGC(SP) hostname =: srmgc-sp
SR-MGC(SP) SIP-ID =: 1
SR-MGC(SP) MPH-ID =: 1
SR-MGC(TP) IP address =: 10.41.207.125
SR-MGC(TP) Drs Port Number =: 3456
SR-MGC(SP) Standard SIP terminal TimeZone =:
GMT Standard Time
Do you register new data in config files ?
[Yes(y)/Retry(r)/Quit(q)] =:
[When "y" is entered and New Data registration is complete:]
config finish !
[When "q" is entered to stop operation:]
operation stop.
When Domain Name Server (DNS) does not exist in the system, assign the same IP Address as that of
Note 1:
SR S to the DNS address.
This value must be the same as that of SR T in SR–MGC. In addition, if IP–PBX (SIP BOX) is executing
Note 2:
uniform management of IP Address, assign the smallest ID number. This data will be used later in the
data assignment process, so please keep a record of the assigned number.
PCPro: "SIP Server ID" in the ASSDL/ASSDN command.
This message is displayed and SP_CONFIG is finished.
Assigned data is not reflected. This message is displayed and SP_CONFIG stops operation.
VOL.2-2198
<Network Setting Data>
<SIP terminal TimeZone Data>
Confirm whether New Data needs to be
registered.
Enter "y" to register the New Data in the config
files.
Enter "r" to correct the New Data.
Enter "q" to stop the operation without registra-
tion.
Note: When entering "r," an asterisk (*)
will be displayed at the beginning of
the pre–entered data. There is no
need to re–enter the pre–entered
data (press Enter key only at the
time of data entry). However, en-
tered data will not be reflected at
this time.
SR-MGC