NEC Univerge sv8500 Manual page 2994

1. Manual mode
2. Automatic mode
SRC: Return to the Configuration Menu
Default setting is "1: MANUAL".
Note 1:
(b) Press the SRC key. The display returns to the second page of the Configuration Menu.
Do not change this data.
Note 1:
(c) To assign data to additional configuration items, refer to the Selecting a Configuration Item section.
When finished, proceed to the Updating the Configuration Data section.
5. PAGE CONTROL
This item specifies the operation mode of a paging device. The following two modes are available:
Manual Mode
Manual mode is available when the PGADP (PA-M87) circuit card is mounted in the system. When the
PAGE key is pressed, the system starts paging and the PAGE lamp lights. When the PAGE key is pressed
again, the paging stops and the PAGE lamp goes off.
Automatic Mode
In Automatic mode, the system starts or stops paging automatically, when a call is connected/disconnected.
Note that the PAGE key is not effective in Automatic mode.
(a) Press the desired number. An asterisk (*) shows the selected number.
1. Manual mode
2. Automatic mode
SRC: Return to the Configuration Menu
2: AUTO
[CONFIG MENU P2] VER x
1: REC CONTROL
2: PAGE CONTROL
3: SUP CONNECTION
[PAGE CONTROL]
*1: MANUAL
Note 1
2: AUTO
VOL.3-507
CHAPTER 4
SRC: prev page
DEST next page
Release: exit
Answer: update
Note 1
SRC: menu
CONFIGURATION SETUP