NEC Univerge sv8500 Manual page 2382

[For FP85-108 S5 or earlier version]
• Copy office data: perform the CMNT command; open the Office Data Copy tab.
• Specifying SR-MGC: Select if you want to copy office data to specific SR-MGC(S)s.
SR-MGC number: Click on SR-MGC numbers to which you want to copy office data; the
• All SR-MGC (en bloc specifying): Select if you want to copy office data to all SR-MGC(S)s.
SR-MGC numbers whose corresponding SR-MGCs are accommodated are indicated in yellow; non-ac-
Note:
commodated numbers are indicated in gray.
In an FCCS network, SR-MGC numbers accommodated in backup nodes are indicated in magenta
Note:
(pink). You cannot specify them as copied SR-MGCs.
* The meanings of displayed data are as follow.
Indicated Color
Yellow
Magenta (Pink)
STEP 16: Initialize the SR-MGC(S).
If office data are successfully copied, the MGC is supposed to request the SR-MGC(S) to initialize. So
after finishing copy process, wait for the SR-MGC(S) to be initialized (about five minutes) without any
action.
STEP 17: Paste the label.
Paste the label attached to the CF card onto the main unit of SR-MGC(S).
The location where to paste the label is stated on the pasteboard of the label.
Note:
Now you are done. SR-MGC(S) should be set up.
[For Reference]
Especially in the case of the following, you definitely need to initialize the SR-MGC(S).
• You performed office data copy against an SR-MGC(S) whose CF card did not have any office
data file.
• You performed office data copy after changing MGC data which needed initialization.
numbers turn yellow. Click on a number again if you want to eliminate;
the number turns white, meaning non-specified.
Gray SR-MGC Number is not accommodated
White No copying process request
On standby (Already requested to execute the copying
process)
Blue Under copying process
Green Succeeded in copying process
Red Failed in copying process
Cannot execute, because SR-MGC is assigned as the
Backup node
VOL.2-2129
Status of SR-MGC
SR-MGC(S)
Note 4