NEC Univerge sv8500 Manual page 3074

4.4 Maintenance Settings
This section explains each setting on the Maintenance Settings Menu. The Maintenance Settings Menu has the fol-
lowing items:
• Download Menu
• Hard Reset
• Factory Value
• Simple Test Mode
• Config Password Mode : Set the control method of Configuration Password.
STEP 1: To open the SIP Settings Menu, select "4. Maintenance Settings" by pressing "4" on the Main Menu.
STEP 2: The Maintenance Settings Menu appears as follows:
"6. Auto Config" is not supported by DtermIP (SIP) with Firmware Version 4.1.x.x.
Note:
: Set the downloading-related data.
: Reset DtermIP (SIP) without saving the data (hard reset).
: Reset the DtermIP (SIP) to its factory defaults.
: Perform the phone test.
Main Menu
1.Network Settings
2.SIP Settings
3.Audio&Visual Settings
4.Maintenance Settings
5.Terminal Information
Up Down Cancel
Maintenance Settings Menu
41.Download Menu
2.Hard Reset
3.Factory Value
4.Simple Test Mode
5.Config Password Mode
6.Auto Config
Up
Down
VOL.3-587
CHAPTER 4 CONFIGURATION SETUP
Save
Exit